MB 350 is an adhesive filled with several different particles, offering a very high adhesion and used mainly on wood. It is used in the marine industry, to fill holes, or to glue walls with corner joints, this technique can reduce the use of screws

With hardener 6 it can be applied in very thin layers, or in a single, several mm's thick, layer

Hardener 8 is used for small quantities because of its high exothermic peak

It is very easy to apply, thanks to its' viscosity, it leaves a good finish, but can be sanded if required

Standard colours are clear and mahogany

Excellent adhesion with most materials is possible without the use of primer, provided surfaces are clean, sanded and free of dust. To be certain, a primer can be applied in layers of 150gm/m² a few hours before the application of the putty

Primer for wood, or foam - use our WOOD RX with a brush

Primer for steel or composites - use our ED 404 with a spray gun

Primer for concrete - use our SB 1 with a brush

It is very important to respect the following ratios between resin and hardener

CAUTION

Use in a well ventilated area. May cause irritation. Avoid prolonged or repeated skin contact and wear the appropriate protective equipment. If contact with skin does occur, wash the affected area thoroughly with soap and water, do not use solvents. If in contact with the eye rinse immediately with plenty of water and seek medical advice. Ensure all persons likely to work, or come into contact with these products have been provided with the correct safety instructions.

Any technical recommendations given by us are not binding on us. Prospective users should conduct their own trials to determinate whether our products are suitable for the intended purpose. Our liability is governed by our general conditions of sales.