AMS 40 is an adhesive liquid with high viscosity, used to assemble all kind of flat material together. It is a very good adhesive for composite on composite, wood on composite, and aluminium on aluminium. With regard to aluminium, it can successfully be used to glue aluminium honeycomb to aluminium flat panel.

For most materials, no primer is required, provided the surfaces to be glued are clean, sanded and free of dust. To be certain primer can be applied in very thin layers.

Primer for wood, or foam : use our WOOD RX with a brush

Primer for steel, aluminium or composites : use our ED 404 with a spray gun

You must ensure, AMS 40 is completely applied to all the surface areas which are to be glued, apply a steady pressure, in order to keep a regular film of adhesive between the two surfaces to be glued ( 300 to 600 µ).

It is very important to respect the following ratios between resin and hardener

CAUTION

Use in a well ventilated area. May cause irritation. Avoid prolonged or repeated skin contact and wear the appropriate protective equipment. If contact with skin does occur, wash the affected area thoroughly with soap and water, do not use solvents. If in contact with the eye rinse immediately with plenty of water and seek medical advice. Ensure all persons likely to work, or come into contact with these products have been provided with the correct safety instructions.

Any technical recommendations given by us are not binding on us. Prospective users should conduct their own trials to determinate whether our products are suitable for the intended purpose. Our liability is governed by our general conditions of sales.